Race Ramps™ Standard Portable Pit Stop Ramps - 6,000 lbs. Capacity

Use the Race Ramps™ Solid Portable Pit Stop Ramps for displays and vehicle maintenance. Manufactured from a lightweight, slip-resistant high-density foam which will not scratch or dent floor or vehicle, each ramp weighs a total of 175 lbs. and can be broken down into parts weighing no more than 40 lbs each. The 10 degree angle is ideal for low-profile vehicles, and the car platform is able to accommodate a wheel base from 98" to 110" wide. When not in use, this pit crew ramp can be stacked in a 65" high space for storage.

They're light enough to bring with you to the track, keep on hand in your personal garage, or simply leave out in your workshop for everyday use. The multi-piece design is easy to assemble with pieces that weigh no more than 40 pounds; and once a car is positioned on top, the center pieces and inclines can be removed for even better accessibility under the car and around the perimeter. The ramp platform provides 14 inches of lift and can accommodate a wheel base of 90 to 115 inches and tires up to 14 inches wide. Each incline has a 10-degree approach angle. The entire ramp system can support up to 6,000 pounds. An additional set of inclines is available if you wish to have ramps at both ends, and you can choose between the standard model, or the racer model with removable scale cutouts.

These ramp platforms are constructed of 100% solid, high-density foam with a rugged anti-slip coating that results in a lightweight ramp solution that is strong, yet durable. They won't slide on any surface, including garage and workshop floors.

Before using the ramps ensure other persons are clear of the vehicle and the ramps. Ensure that the ramps are free from damage or corrosion before use. Use only a single pair of wheel ramps at the front or rear, do not use two ramps on one side of the vehicle. Position the ramps in line with the wheels, with the steering wheel pointed straight and the incline against the tire tread. Carefully drive the vehicle onto the automotive ramps until it is in the correct position. Turn the engine off, apply the parking brake, get out of the vehicle and securely chock the remaining wheels on the ground. Before starting work, walk around the vehicle ensuring it is securely positioned. Always use a jack stand if a person will be going under the vehicle. On completion of the work, check the parking brake is still firmly on and remove the chocks. It is important to drive very slowly when coming off the ramps to prevent the automotive bodywork from making contact with the car ramp. Exercise caution when using these car ramps with a trailer or three wheeled vehicles.